Warn WIRELESS CONTROL SYSTEM 90287 User Manual download pdf (Page 5)

OUT

LED indicator light

Power IN

Power OUT

Press and hold

both buttons

for 3 seconds

to activate the

wireless system.

TROUBLESHOOTING

If the winch does not power in or out when remote buttons

are pushed:

1. Check that the wireless system has been activated

(GREEN LED on remote is ON).

2. Check that receiver is securely plugged into the control

pack “D” plug.

OPERATION

LED Indicator Light

Steady GREEN - system active and ready to use

Steady RED - winch powering in or out

Flashing RED during winching - battery low

Turn On Sequence:

1. Activate the system by pressing both buttons on the

wireless transmitter simultaneously and holding for 3

seconds until GREEN light illuminates.

2. The winch system is now operational.

3. Press the power IN or power OUT button as needed.

Turn Off Sequence:

1. Deactivate the system by pressing both buttons on

wireless transmitter simultaneously and holding for 3

seconds until GREEN light turns off.

Press and hold

both buttons

for 3 seconds to

deactivate the

wireless system.

CAUTION

TO AVOID MINOR OR

MODERATE INJURY:

• Always be aware that obstacles

and other radio transmission sources

may affect performance.

• Always insure the matching WARN

transmitter is closer to its receiver

than other transmitters in use during

winching.

This WARN Wireless Control

System has been designed

to minimize interference

from other sources of radio.

CAUTION

TO AVOID MINOR OR MODERATE

INJURY:

• Always use wired remote when

intermittently “jogging” winch.

Programming LED

Programming button

PROGRAMMING THE RECEIVER

The hand held remote (transmitter) is programmed from

the factory to communicate with your specific receiver.

Under normal circumstances programming will not be

necessary. However, any replacement remote must be

programmed to communicate with your receiver. Use the

following procedure:

1. Insure the system is properly installed and connected.

2. Activate the new remote by pressing and holding both

buttons on the wireless handheld remote until the

GREEN LED illuminates.

3. Press and hold the receiver programming button for

at least five (5) seconds until the RED LED on the

receiver illuminates and stays on.

4. Release the programming button.

5. Press the power OUT button on the remote for at least

one (1) second until the RED LED on the receiver

turns off. Programming is now complete.

NOTE: Only one remote can be programmed for each

receiver.

WARRANTY

Please refer to the warranty sheet enclosed with your

winch for details.

REPLACEMENT PART NUMBERS

Ordering information: Parts may be obtained through your

local dealer or distributor.

Part Number Description

PN 90289 Receiver Module

PN 74524 Holster

PN 74520 Replacement transmitter (Remote)

The above list represents the most commonly requested

replacement parts. A full listing of replacement and

service parts are available. Check with your WARN

authorized dealer or on the web: www.warn.com

WARNING

TO AVOID

SERIOUS INJURY OR DEATH:

• Never attempt to service

components inside transmitter or

receiver.

• Always consult an authorized

WARN service center for service or

warranty.

1 2 3 4 5 6 7 8 9 10 ... 41 42

Comments to this Manuals

No comments

Warn WIRELESS CONTROL SYSTEM 90287 User Manual Page 5

Comments to this Manuals